Please refer to the diagram below.

The top section displays how to wire the power connectors from each fan.

• Plug the PWM connectors from each of the fans into the included splitter cable (11)

• Plug the splitter into the CPU_FAN header on your motherboard (for the 120R, there will be no splitter).

• The 3pin fan connector from the pump can be plugged into any other fan header that is available (CPU_OPT, AIO, PUMP, SYS_FAN, CHAS_FAN).

The lower part of the diagram covers the wiring of the RGB lighting.

• Connect the RGB connector from the pump into the female RGB connector from one of the fans

• Continue to daisy chain the rest of RGB connectors from the fans together in the same type of fashion (if you have a 120R, this part will not be part of your installation since the 120R includes one fan).

• You would connect the last RGB connector of the daisy chain into the RGB sync cable (10) and plug it into a compatible 12v RGB header.

文章

文章具体内容